CIP Training
Pro C9200 series
Adjustment Settings for Operators
CIP Training C7200 series
Adjustment Settings for Operators
0512 Fusing Belt Smoothing Setting
Specify the condition to execute Fuser Belt smoothing.
Setting Items Selection Default Value
Auto Exe: Belt Scratches Off
Automatic Execution
Most Frequently
Automatic Execution:
Set by User
Automatic Execution
Feed Speed High
Middle
Low 1
Low 2
Low 3
Low 3
0513 Smooth Fusing Belt
Smooth the Fuser Belt to remove vertical and horizontal lines from the printouts.
Vertical or horizontal lines may appear when printing on paper that is larger than
the paper used immediately before it.
In such case, press [Execute] to cause a roller to press on the fusing belt and prevent
vertical and horizontal lines. Select [Belt Scratches] if vertical or horizontal lines
appear on the edges of the paper. Select [Uneven Gloss: Short Time] if there are
patches of uneven glossiness.
Setting Items Selection
Belt Scratches
Uneven Gloss: Short Time
Press [Execute].
0516 Manage Multiple Fusing Units by Counter
Display the counter of Fusing Unit parts.
Setting Items Selection Default Value
Fuser Unit No. Unit 1
Unit 2
Unit 3
Unit 4
Unit 1
To Next Page
Loading...
