Ricoh Pro C9200 Series - Finishing: Finisher; 0601 Staple Position: Across Feed 1

CIP Training
Pro C9200 series
Adjustment Settings for Operators
CIP Training C7200 series
Adjustment Settings for Operators
Setting Items Remarks
Curt:Dist:Fuser Unit
Curt:Dist:Fusing Belt
Curt:Dist:Fusing Rllr
Curt:Dist:Press Rllr
Curt:Dist:Thermistor
Curt:Dist:Separation Pad
Curt:Dist:Fusing Heater
Curt:Dist:Gear Set
Curt:Page:Fuser Unit
Curt:Page:Fusing Belt
Curt:Page:Fusing Rllr
Curt:Page:Press Rllr
Curt:Page:Thermistor
Curt:Page:Separation Pad
Curt:Page:Fusing Heater
Curt:Page:Gear Set
Curt:Paper Feed :Clng Web
Curt:Rot:Clng Web
Curt:Smooting Time
Value display only.
Saved Value specified in Fuser Unit No. is
displayed under Current Value.
Finishing: Finisher
0601 Staple Position: Across Feed 1
Adjust the vertical position of the staple (applied at an edge) when using Finisher SR5050
or Booklet Finisher SR5060.
Press [ + ] to move the stapling position away from the side edge of the sheet or [ - ] to
move it toward the edge.
Leading
edge
Paper feed direction
Trailing
edge
DFZ001