CIP Training
Pro C9200 series
Adjustment Settings for Operators
CIP Training C7200 series
Adjustment Settings for Operators
Machine: Image Quality
0201 Execute Image Quality Adjustment
Execute image control or color registration adjustment manually.
The machine adjusts the image density. The time required for each process is as
follows: about 5 minutes for [Adjust All], about 1.5 minutes for [Adjust Image
Density], about 1 minute for [Density Difference: Acr Fd], about 2.5 minutes for
[Density Difference: With Fd], and about 40 seconds for [Color Registration]. A
message appears on the control panel while the process is in progress. Do not pull out
the mainframe front covers while the message is being displayed.
Setting Items Values
Adjust All
Adjust Image Density
Density Difference: Acr Fd
Density Difference: With Fd
Color Registration
Press [Execute].
• The machine executes automatic image quality adjustment after a set interval
or after printing a specified number of sheets. However, you can also
manually initiate automatic image density adjustment whenever you want.
0202 Maximum Image Density
Adjust the toner adhesion amount to the intermediate transfer belt during the image
density adjustment.
When the degree of coloration differs depending on the difference in the degree of
pigmentation, adjust the toner adhesion amount.
Press [ + ] or [ - ] to increase or decrease the toner adhesion amount.
If you change the setting value, [Adjust Image Density] is automatically performed
before the machine starts printing.
Setting Items
Default
Value
Max.
Value
Min.
Value
Step Unit
Black
Cyan
Magenta
Yellow
0 5 -
5 1 -
• Increasing the toner adhesion might reduce fusibility, causing toner splatter or distorted text
and thin lines.
To Next Page
Loading...
