Web Image Monitor –
Static IPv4 –
Connecting Ethernet
1. Open the port cover
2. Plug the Ethernet cable into
the Port
3. Connect the other end of the
cable to the printer’s
network, such as to a hub.
Check the LEDs on the
Ethernet port
1. Indicator (green): Lights
whenever the printer is
properly connected to the
network
2. Indicator (yellow): Lights
whenever the printer is
sending or receiving data via
the network
1 2
Web Image Monitor –
Static IPv4 Setup -
Connecting via
Ethernet
1
2
3
To Next Page
Loading...
