Ricoh Ri 100 - Web Image Monitor - Static IPv4 Setup - Print Configuration page

Web Image Monitor –
Static IPv4 Setup - Print
Configuration page
1. Load print media in the cassette
2. Press the [▾/Menu] key
3. Press the [▴] or [▾/Menu] key
to display [List/Test Print], then
press the [#Enter] key
4. Press the [▴] or [▾/Menu] key
to display [Config. Page], and
then press the [#Enter] key
5. Press the [Start] key. The
Configuration page is printed
6. Set another print media
7. Print all configuration pages by
repeating steps 5 and 6
8. Press the [Escape] key
<Menu>
List/Test Print
<List/Test Print>
Config. Page
2
3 4
5
8
Return to
Appendix
Return to
Table of
Contents