Ricoh Ri 100 - Control Panel Network Setup - Static IPv4 - DHCP

Control Panel
Network Setup -
Static IPv4 - DHCP
The following example explains how to
allocate an IPv4 address.
1. Press the [Power] key
2. Press the [▾/Menu] key
3. Press the [▴] or [▾/Menu] key to
display the [Host Interface] menu, and
then press [#Enter] key
4. Press the [▴] or [▾/Menu] key to
display [Network Setup], and then press
[#Enter] key
5. Press the [▴] or [▾/Menu] key to
display [DHCP], and then press [#Enter]
key
6. Press the [▴] or [▾/Menu] key to
display [Off], and then press [#Enter]
key
A. Off = Disable | On= Enable
<Menu>
Host Interface
<Host Interface>
Network Setup
1
2
3 4
5
6
<Network Setup>
DHCP
<DHCP>
Off