Ricoh Ri 100 - Web Image Monitor - Static IPv4 Setup - 4

Web Image Monitor –
Static IPv4 Setup - 4
10. To use Static IP Address, DHCP will be
switched to inactive
11. Enter the desired IP Address
• To get an IP Address for the printer, contact
your network administrator.
12. Enter the desired Subnet Mask Address
• To get a Subnet Mask Address for the
printer, contact your network
administrator.
13. Enter the desired Gateway Address
• To get a Gateway Address for the printer,
contact your network administrator.
14. Select OK to confirm the values entered
10
11
12
13
14