Ricoh SG 3110DN User Manual

6
5. Firmware Update Operating Instructions
These instructions explain how to update the firmware of the machine.
Before you start the update, make sure of the following:
The machine is in standby mode.
No applications are running on the computer.
The machine is connected to the computer with a USB cable or via network peer-to-
peer.
The following procedure uses Windows 7 screenshots and is based on the SG3110DN
model.
Depending on the printer driver and its settings, update procedures might vary.
Open the properties dialog box for the machine in use and check the port status.
If "bidirectional support" has been enabled in the printer properties dialog box:
Update the firmware by following the update procedure shown in section 5.1.
If "bidirectional support" in the printer properties dialog box has been disabled:
Update the firmware by following the update procedure shown in section 5.2.
* We recommend you enable bidirectional support.
•
•
•
•
•

Ricoh SG 3110DN Specifications

General

Paper Capacity	250 sheets
Connectivity	USB 2.0, Ethernet
Duplex Printing	Yes
Operating System Compatibility	Windows, Mac OS, Linux
Print Resolution	3600 x 1200 dpi
Print Speed	29 pages per minute
Paper Size	A4, A5, A6, B5
Print Technology	Gel-based inkjet