Ricoh SG 3110DN User Manual

2. Preparing for Printing
This chapter describes installation and setup procedures.
Setup Procedure
This section explains the tasks necessary for printing.
Install and set up the machine by following the steps in the order shown.
Step Task Reference for Full Details
1 Check the installation environment. page 36 "Checking the Computer and
Installation Area"
2 Check the supplied items. page 42 "Checking the Supplied Items
and Unpacking the Machine"
3 Attach the units and options. page 26 "Attaching and Detaching Units
and Options"
4 Install the print cartridges. page 44 "Installing the Print Cartridges"
5 Plug the power cord in and turn the power
on.
page 47 "Plugging in the Power Cord
and Turning the Power On"
6 Load paper. page 100 "Loading Paper"
7 Perform a test print. page 128 "Printing a Configuration Page"
8 Connect the machine and computer and
install the software using "Quick Install".
page 51 "Connecting the Computer and
Installing the Software (USB Connection)"
page 55 "Connecting the Computer and
Installing the Software (Network
Connection)"
If you are using a Macintosh, see
page 179 "Using the Machine with a
Macintosh".
35

Ricoh SG 3110DN Specifications

General

Paper Capacity	250 sheets
Connectivity	USB 2.0, Ethernet
Duplex Printing	Yes
Operating System Compatibility	Windows, Mac OS, Linux
Print Resolution	3600 x 1200 dpi
Print Speed	29 pages per minute
Paper Size	A4, A5, A6, B5
Print Technology	Gel-based inkjet