• [Paper Misfeed]/[Out of Paper]/[Replace Print Cartridge Soon]/[Call Service]/[Replace
Print Cartridge]/[Cover Open]
Select which items to send notifications about.
[SNMP] tab
•
[SNMP]
Select whether to enable the machine to use SNMP services.
• [Trap]
You can specify [Target Trap], [SNMP Management Host 1], and [SNMP Management Host
2].
• [Community]
You can specify [Get Community] and [Trap Community].
• [System]
Enter [Location] and [Contact] that are displayed on the top page.
[SMTP] tab
You can specify [Primary SMTP Server], [Port No.], [Authentication Method], [User Name],
[Password], [Device E-mail Address], and [Server Timeout (seconds)].
[POP3] tab
You can specify [POP3 Server], [User Account], [User Password], and [Authentication].
[Wireless] tab
This function is available for only SP 220Nw and SP 221Nw.
• [Wireless LAN Status]
The status of the following items is displayed:
[Wireless LAN Status], [MAC Address], [Communication Mode], [SSID], [Wireless Signal
Status], and [Wireless].
• [Wireless LAN Settings]
• [SSID]
Enter the SSID name. Can contain 32 characters.
When you click [Scan List], a list of access points that is currently available is displayed.
You can select the SSID name from the list.
• [Communication Mode]
[Infrastructure] is selected by default. Therefore, connect the machine to a wireless router
or access point.
• [Authentication]
Select an authentication method.
• [WPA2-PSK]
Using Web Image Monitor
49
To Next Page
Loading...
