Changing Defaults
Function priority
When the operation switch is turned on or when the System Reset is done automatically, the copier
screen is shown. This is a factory default. You can change this initial setting so that the scanner,
facsimile, or another function screen appears first instead of the copier screen. If you want to
change this setting, specify the function in “Function Priority” under System Settings. For details, see
“System Settings”, Network and System Settings Reference .
Changing defaults for the initial display
You can configure the settings of the initial display of the scanner and facsimile functions so that the
initial display contains the functions you use most often.
For example: if the default selection is one-sided scanning and the function you use most frequently
is two-sided scanning, you can change the default selection to two-sided scanning.
For details about how to configure the scanner's initial display, see “Changing the Default
Functions of the Scanner's Initial Display”, Scanner Reference .
For details about how to configure the facsimile's initial display, see “Changing the Default
Functions of the Fax's Initial Display”, Facsimile Reference
.
3. Appendix
42
To Next Page
Loading...
Need help?
General
