53
then power on RD6012P, you will see the blue LED blinks once. Set the communication interface to
WIFI, restart RD6012P, then place the RD6012P and the mobile phone
close to the 2.4G router (the mobile phone must also be under the
same 2.4G network, and the router must disable the AP isolation
function and the WMM function).
RD6012P will wait for the phone to connect as shown in Figure
23. Press “EA” to choose Network distribution, it will show like Figure
24, then enter the WiFi password and click INITIALIZATION. Wait
about 20 seconds.
R
D6012P will obtain the IP address of your phone(Figure 26), if it
shows right,
confirm that “device displays sever IP”, and click “CONFIRM”, wait
30s (Figure 25)，APP shows connection successful, RD6012P will start
automatically, the network distribution success, return to the main
page and click “DA” to connect.
If the distribution network fails, please power off the module
and re-operate in the same way (multiple networking failures you can
watch the video and try to use the hotspot of the mobile phone to test).
To Next Page
Loading...
