DG1000 Command System RIGOL
Programming Guide for DG1000
AM
In AM, the amplitude of carrier varies with the instantaneous voltage of the
modulating waveform. For DG1000, CH1 can output AM modulated waveform. AM
commands could be used for these settings: modulation source, modulating waveform,
modulating frequency, modulation depth and AM modulation state.
DG1000 supports following AM commands:
1. AM:SOURce
2. AM:SOURce?
3. AM:INTernal:FUNCtion
4. AM:INTernal:FUNCtion?
5. AM:INTernal:FREQuency
6. AM:INTernal:FREQuency?
7. AM:DEPTh
8. AM:DEPTh?
9. AM:STATe
10. AM:STATe?
To Next Page
Loading...
