Rigol DP1308A

RIGOL Chapter 2 Front Panel Operations
User’s Guide for DP1308A
2-10
NOTE
In CC state, the instrument will switch to the CV state in terms of the preset
setting value of the voltage automatically if the output voltage exceeds the
setting value resulting from the increase of load, meanwhile, the output
current will decrease pro rata. To resume CC state, decrease the load or
increase the voltage setting value.
7. O.V.P*
In channel output mode, press O.V.P to enter into the setting state, you can
input needed value using number keyboard and then press O.V.P to enable (or
disable) O.V.P protection. If the parameters of O.V.P have already been set, press
O.V.P to directly enable (or disable) O.V.P protection.
Figure 2-10 Set the O.V.P
NOTE
 If channel output is disabled, the O.V.P function can not be enabled
but only for inputting value.
 If the output voltage beyond the value of overvoltage protection, the
output will be disabled automatically.
 *: Please use O.V.P function as required.