Chapter 2 Front Panel Operations RIGOL
User’s Guide for DP1308A
8. O.C.P*
In channel output mode, press O.C.P to enter into the setting state, you can
input needed current value using number keyboard and then press O.C.P to
enable (or disable) O.C.P protection. If the parameters of O.C.P has already been
set, press O.C.P to directly enable (or disable) O.C.P protection.
Figure 2-11 Set O.C.P
NOTE
If channel output is disabled, the O.C.P function cannot be enabled but
only for inputting value.
If the output current beyond the value of overcurrent protection, the
output will be disabled automatically.
*: Please use O.C.P function as required.
To Next Page
Loading...
