Chapter 3 Remote Control
DP1308A Programmable Linear DC Power Supply confirms to LXI-C standard and
supports remote control. Please take the following steps to operate:
1. LAN Setting
Make sure DP1308A has been connected to local area network, then press I/O →
LAN to enter LAN parameter setting interface. Set and obtain IP address referring
to the introduction of “I/O Setting” in chapter 2.
Figure 3-1 Set the LAN
2. Remote Control
(1) Input IP address obtained from LAN Setting interface in internet explorer,
entering to the following welcome interface.
Figure 3-2 Welcome interface
A hint “identification!” will pop up on the screen of the instrument after clicking
“Web Identification indicator”. See figure 3-2, this page is available to overview
To Next Page
Loading...
