Timer Setting
In timer setting interface, you can set user-defined voltage, current and output time
as well as up to five groups timing output for each channel.
See the figure below: the interface is divided into two parts: parameter setting area
(right) and waveform display area (left).
Figure 2-34 Timing Settings
In parameter setting area, three kinds of parameters for each output are available to
set: voltage (Volt), current (Curr) and time (Set).
In waveform display area, the system displays waveform based on specified voltage
(Volt) and current (Curr) for user to view the output state more clearly and directly.
General condensed summaries:
If Timing output is disabled, the parameter “Left(s)” in parameter setting area is
equal to “Set(s)”.
If Timing Output is enabled, the instrument starts output with first group of
settings after you enable relative channel, and the value of “Left(s)” is on the
decrease until to 0, at this moment, the instrument enters next group and so on
until finish outputs of all settings.
To Next Page
Loading...
