Timing Output
Press Timer to enable the timing output of current channel, at this moment, a hint
“Timing will change the output of channel possibly, do you go on?” will pop up, then
click OK, the button light will go on and a “Clock” icon and the corresponding timing
parameters are shown on the screen. See the figure below. The instrument will start
output after you turn on the current channel until finishing all timing outputs (at the
same time, the light of Timer button goes out.).
If no timing parameters have been set before enabling the timer, the system will enter
“Timer Setting” Interface automatically after you press Timer (the light of Utility
goes on). In timing mode, if you turn off the channel under timing, the timer will stop
until it is enabled again. However, the timer would be disabled once you press Timer
during timing.
Figure 2-12 Timing output (in focus display mode)
In focus display mode, the character “Set” on the screen denotes the current output
voltage and current setting value while “Next” denotes the next output voltage and
current setting value. The next output value does not displayed in normal display
mode, see the figure below.
Figure 2-13 Timing output (normal display mode)
To Next Page
Loading...
