EasyManua.ls Logo

Rigol DP800 Series - Timer:cycles

Rigol DP800 Series
134 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
RIGOL Chapter 2 Command System
2-64 DP800 Programming Guide
:TIMEr:CYCLEs
Syntax :TIMEr:CYCLEs {N|I}[,<value>]
:TIMEr:CYCLEs?
Description Set the number of cycles of the timer.
Query the current number of cycles of the timer.
Parameter
Name Type Range Default
{N|I} Discrete N|I N
<value> Integer 1 to 99999 1
Explanation The number of cycles is defined as the number of times that the instrument
performs timing output according to the preset voltage/current.
The total number of groups in each timing output = the number of groups ×
the number of cycles; wherein, the number of groups is set by
the
:TIMEr:GROUPs command.
The power supply will terminate the timer function when the total number of groups
of outputs is finished. At this point, the state of the power supply depends on the
setting of the
:TIMEr:ENDState command.
Return Format The query returns I or N,<value>, for example, N,20.
Example :TIME:CYCLE N,20
:TIME:CYCLE?
Related
Commands
:TIMEr:ENDState
:TIMEr:GROUPs

Table of Contents

Other manuals for Rigol DP800 Series

Related product manuals