RIGOL Chapter 5 Trigger
5-16 DS4000E User’s Guide
Note:
― The minimum runt pulse width should be lower than the maximum runt
pulse width.
― The larger the rotation amplitude of the outer knob of the navigation
knob is, the faster the variation of the value will be. When you need to
adjust the maximum runt pulse width/minimum runt pulse width within
a relatively larger range, this function can help you quickly finish the
setting.
5. Specify the trigger mode
Press Sweep to select “Auto”, “Normal” or “Single” (please refer to “Trigger
Mode”). The corresponding status light of the current trigger mode in the
trigger control area (TRIGGER) at the front panel turns on.
6. Set the trigger holdoff and noise rejection
Press Setting to enter the trigger setting submenu. In this submenu:
1) Press Holdoff to adjust the holdoff time (please refer to “Trigger
Holdoff”). The range is from 100 ns to 10 s.
2) Press Noise Reject to turn the noise rejection on or off (please refer to
“
Noise Rejection”).
To Next Page
Loading...
Need help?
General
