Rigol DS4024E User Manual

RIGOL Chapter 6 Operations and Measurements
6-22 DS4000E User’s Guide
To Make One-key Measurement
DS4000E provides the one-key measurement function through which you can
measure the 29 kinds of waveform parameters as shown in the table below. Please
turn on the channel to be measured before making measurement.
Table 6-5 29 Waveform Parameters
Parameter Type Parameter Name
Time Parameter
Period, Freq, Rise Time, Fall Time, + Width, -Width,
+Duty, -Duty (please refer to “Time Parameters”)
Delay and Phase
Parameters
Dly A
→B , Dly A →B , Dly A →B , Dly A →B ,
Phs A
→B , Phs A →B , Phs A →B , Phs A →B
(please refer to “Delay and Phase Parameters”)
Voltage Parameter
Vmax, Vmin, Vpp, Vtop, Vbase, Vamp, Vavg, Vrms-N,
Vrms-1, Overshoot, Preshoot (please refer to “Voltage
Parameters”)
Area Parameter Area, Per.Area (please refer to “Area Parameters”)
You can perform one-key measurement following the steps below.
1. Specify the measurement source
The measurement source selection methods are different for different waveform
parameters.
 Time, voltage and area parameter measurements
Press Measure  Source, turn the multi-function knob to select the
channel to be measured and press the knob. You can also press Source
continuously to switch the current measurement source. The channels
available are CH1 to CH4 and MATH.
Note:
― You can switch the measurement source by switching the current
active channel (press CH1 to CH4 at the front panel).
― When the math operation type is set to “FFT”, the measurement source
cannot be set to “MATH”.
 Delay and phase parameter measurements
Press Measure  Setting  Type, turn the multi-function knob to
select “Delay” or “Phase” and press the knob. You can also press Type

Rigol DS4024E Specifications

General

Brand	Rigol
Model	DS4024E
Category	Test Equipment
Language	English