50
Processing Principles
FFT processing cycle (1 frame processing time)
The FFT processing cycle depends on the zoom (ZM) setting, as listed below.
The cycle for 1 kHz and above is the same as for 500 Hz.
The data of 2 kHz and below are available for real time analysis.
Mass Memory
The VA-11 incorporates a memory for storing measurement results and
measurement parameters for the vibration meter mode and analyzer mode.
The number of memory slots is 500, identified by a memory address.
Important
If you hold down the STORE key on the sheet
switch panel while turning on the power, all data
in the mass memory will be cleared.
To Next Page
Loading...
Need help?
General
