Page 54
Note: This application is available only if a GSM/GPRS module is installed in your system.
Operation SMS Message Structure Example
Full Away Arm [Code] A 1234A
Home Arm [Code] H 1234H
Group Arm [Code][G][Select a one Group
A/B/C/D])
1234GA
Full disarm [Code] D 1234D
Arm by partition [Code] A [Partition No.] 1234A1
Home Partition
Arm
[Code] H [Partition No.] 1234H1
Group Arm by
Partition
[Code] G [Select one Group A/B/C/D]
[Select partitions]
Disarm by Partition [Code] D [Partition No.] 1234D1
Bypass a zone [Code] B [zone number] 1234B05
Un-bypass a zone [Code] UB [zone No.] 1234UB05
Activate Output [Code] UOON [UO No.] 1234UOON1
Deactivate Output [Code] UOOFF [UO No.] 1234UOOFF1
Change FM
number
[Code] FMPHONE [FM serial number]
NEW [New Phone No.)
1234FMPHONE 3
NEW0529692345
Get system status [Code] ST 1234ST
Get last alarm [Code] AL 1234AL
Get SIM credit level
(for prepaid cards)
[Code] CR 1234CR
Notes: SMS commands are not case sensitive (they can contain both capital, small or mixed letters). A
separator between command words is not required, although it is accepted.
SMS Confirmation Message
A confirmation message following a SMS operation is sent to the user, upon request, by
adding the letters “RP” at the end of the SMS messages listed below.
Example:
To Next Page
Loading...
