Page 55
1234 A RP - A confirmation message following an arming operation is sent to the user.
Confirmation or Fail operation messages can be assigned to the actions of arming,
disarming, bypassing, activating outputs or changing follow me definitions.
Appendix E – System Testing and Maintenance
The LightSYS™2 should be tested once a week. Also, the system should be checked
by a qualified technician at least every 3 years. Your weekly test should include:
• System arming System disarming Creating an alarm
• Testing the zones in the system through a Walk Test, allowing you to
open and then close each protected door and window while listening for the keypad to
beep confirming its operation To perform a Walk Test:
1. Make sure the system is disarmed.
2. Press and enter your code followed by .
3. Using the arrow keys, scroll to the option Maintenance and press .
4. Select Walk Test and press .
5. Select Full Walk test and press .
6. A beep is heard and the following display appears:
MAKE WALK TEST AND HIT ANY KEY
Walk throughout the protected area and make sure you test every zone in the
system. You have 60 minutes to perform the test.
7. When done, press any key. A list of the tripped zones during the walk test
appears. Use the arrow keypad's keys to scroll through the list of the zones
logged during the test
8. Press to confirm and exit the walk test mode.
Important Notice
This guide is delivered subject to the following conditions and restrictions:
This guide contains proprietary information belonging to RISCO Group. Such
information is supplied solely for the purpose of assisting explicitly and properly
authorized users of the system.
No part of its contents may be used for any other purpose, disclosed to any person
or firm, or reproduced by any means, electronic or mechanical, without the
express prior written permission of RISCO Group.
To Next Page
Loading...
