3.2.5.1.1.3.5 Quit Timer Output
The screen allows user to exit the Timer output menu.
Pressing “ ” key advances to the “Timer Output” menu (see Section
3.2.5.1.1.3) and pressing “ ” key advances to “Off Delay” menu (see
Section 3.2.5.1.1.3.4).
Pressing “ ” key advances to “Relay Selection” menu (see Section
3.2.5.1).
XXXX
3.2.5.1.1.4.1 Load Health Monitor Configuration
XXXXXXXX
Relay Configuration Edit Mode
Press “ ” key to enter the edit mode and press “ ” and “ ” keys to
navigate between the options.
Pressing “ ” key sets the selected config. and advances to the “Load
Health Monitor” Configuration menu (see Section 3.2.5.1.1.4.1).
Note : The default setting is ‘EnrG’.
The option decides the relay configuration for Load Health Monitor output.
Two options are available:
1. EnrG : Energize on fault
2. d-Enr : De-energize on fault.
Pressing “ ” key confirms the selection and advances to the “Quit” screen
menu for selected relay and pressing “ ” key advances to the “Load
Health Output” menu (See section 3.2.5.1.1.4).
XXXXXXXX
59
To Next Page
Loading...