This screen allows the user to assign topup recharge for the energy
parameter. Pressing “ ” key accepts the present setting and advance to
“New recharge” screen (see section 3.2.5.1.1.5.4) and pressing “ ” key
accepts the present setting and advance to “Unit cost” screen (see section
3.2.5.1.1.5.2).
Pressing the “ ” key advances to edit mode and “ ” and “ ” keys
scrolls through the required topup recharge.
Pressing the “ ” key accepts the present decimal point position and advances to first digit. Press the “ ”
and “ ” keys through scroll the values of the first digit.
Press the “ ” key to advance to next digit. Similarly, enter second, third and fourth digits also.
Unit cost ranges from 1 to 999.
Note: Default value is set to “1.000”.
XXXXXXXX
(Flashing decimal point indicates the cursor position).Initially the decimal
point must be selected, pressing the “ ” or “ ” key moves the decimal
point position to the right until it disappears, which means that it has
reached # # # #. after which it returns to #. # # #.
Note: The absence of decimal point in edit mode implies # # # #. decimal
point position.
Unit Cost Edit mode
3.2.5.1.1.5.3 Topup Recharge
XXXXXXXX
61
To Next Page
Loading...