RKC INSTRUMENT CB100 - Wiring Connection Example

4
IMCB04-E9
2. SETTING
2.1 Display Flowcharts in Initialization Mode
If the instrument is changed to initialization mode, the symbol (Cod) for selecting the initialize code is
displayed first. Initializing items are classified into 3 initialize code groups in initialization mode.
There are parameters which are not displayed depending on the specification.
Press the <R/S key while pressing the SET key
Press the <R/S key while pressing the SET key
for two seconds with the unlocked.
Communicatiom setting mode Parameter setting mode
To PV/SV
display mode
To PV/SV dis
p
la
y
mode To PV/SV dis
p
la
y
mode
PV/SV display mode
Press the SET key
for two seconds.
Initialize code selection (Cod)
(SL1)
(SL2)
(SL3)
(SL4)
(SL5)
(SL6)
(SL7)
(SL8)
Initialize code selection (Cod)
(SL9)
(SL10)
SV alarm type selection
(SLH)
(SLL)
Option selection
(STIK)
(STPK)
(STTM)
(dF)
(CTr)
(AH2)
(AH1)
(oH)
(PGdP)
(TCJ)
Special specification
selection 3
Special specification
selection 2
Energized/de-energized,
special specification selection 1
(WTH)
(WTL)
Engineering unit selection
and cooling type selection
Control output type selection
Second alarm type selection,
hold action selection
First alarm type selection,
hold action selection
(SL11)
HBA selection,
LBA selection, etc.
Integral time limiter *
Factor to calculate
integral time
Factor to calculate
proportional band
Time factor assumed to
be safe
Digital filter setting
CT ratio setting
Second alarm
differential gap setting
First alarm
differential gap setting
ON/OFF action
differential gap setting
Decimal point position
setting
Input type selection
Parameters in this initialize code are
only displayed.
Operating time display
unit [Lower digits]
Operating time display
unit [Upper digits]
Holding peak ambient
temperature
Setting limiter [low limit]
Setting limiter [high limit]
Set Cod to 2. Set Cod to 1. Set Cod to 0.
(ILIM)
Explaining the
arrow mark
:
: Press the SET key.
* No display is made for the instrument with the modbus communication specification
(Z-1021 specification).