1. TRANSFER TO MODE
IMCB04-E9
3
1.2 End of Initialization Mode
If the setting is changed, always check all of the set values (SV setting mode, parameter
setting mode).
1. After each parameter is set, keep pressing the <R/S key for two seconds while pressing the SET
key to change the present mode to the PV/SV display mode.
2. Press the SET key for two seconds in the PV/SV display mode state to transfer to parameter
setting mode.
3. Press the SET key to transfer to the set data lock function display (LCK).
4. Press the <R/S key to brightly light the thousands digit on the set value (SV) display unit.
(See 4. on P. 1.)
5. Press the DOWN key to set the numeric value corresponding to the thousands digit to 0 from 1.
(The section in each picture is dimly lit.)
6. Press the SET key to transfer to the next parameter. As a result, the Initialization mode lock state
setting becomes effective.
The parameter to be displayed varies depending on the specification.
R/S
SET
PV
SV
OUT1 ALM1 ALM2OUT2
"
AT
CT1 input value display
R/S
SET
PV
SV
OUT1 ALM1 ALM2OUT2AT
Set data lock function display
Set value
0 : Initialization mode locked
1 : Initialization mode unlocked
To Next Page
Loading...
