1. TRANSFER TO MODE
IMCB04-E9
2
6. Press the SET key to change to the next parameter. Thus, the data in initialization mode is
unlocked.
The parameter to be displayed varies depending on the specification.
7. Press the <R/S key while pressing the SET key for two seconds to change the instrument to
initialization mode. Thus, the symbol (Cod) for selecting the initialize code is displayed first.
R/S
SET
PV
SV
OUT1 ALM1 ALM2OUT2
"
AT
CT1 input value display
R/S
SET
PV
SV
OUT1 ALM1 ALM2OUT2AT
Initialize code selection
display of initialization mode
R/S
SET
PV
SV
OUT1 ALM1 ALM2OUT2
"
AT
CT1 input value display
To Next Page
Loading...
