2. SETTING
IMCB04-E9
20
(3) PGdP (Decimal point position setting)
Any digits other than the units digit are not used. As malfunction may result, do not change
any of these digits.
The decimal point position setting is displayed only for voltage or current input.
Factory set value: 0001
Set value Description
0 No digit below decimal point Decimal point position setting
1 1 digit below decimal point
2 2 digit below decimal point
3 3 digit below decimal point
000 000! Fixed
(4) oH (ON/OFF action differential gap setting)
Setting range
TC and RTD inputs: 0 to 100 °C [°F] or 0.0 to 100.0 °C [°F]
Voltage and current inputs: 0.0 to 10.0 % of span
Factory set value
TC and RTD inputs: 2 °C [°F] or 2.0 °C [°F]
Voltage and current inputs: 0.2 %
(5) AH1 (First alarm [ALM1] differential gap setting) *
Setting range
TC and RTD inputs: 0 to 100 °C [°F] or 0.0 to 100.0 °C [°F]
Voltage and current inputs: 0.0 to 10.0 % of span
Factory set value
TC and RTD inputs: 2 °C [°F] or 2.0 °C [°F]
Voltage and current inputs: 0.2 %
* Not displayed when there is no first alarm (ALM1).
To Next Page
Loading...
