RKC INSTRUMENT CB100 - 3. SETTING FOR COMMUNICATION; Transfer to Communication Setting Mode

2. SETTING
IMCB04-E9
5
2.2 Procedure for Setting Each Parameter
[Example of changing the setting]
When the display unit shows SL1 (Input type selection) in initialize code 0, the following procedure is
for changing the input type from K to J.
1. Change the instrument to the initialize code selection display.
See 1.1 Transfer to Initialization Mode on page 1.
(The section in each picture is dimly lit.)
2. As SL1 belongs to the group of initialize code 0, do not change the initialize code (the units
digit) but press the SET key to change to SL1.
R/S
SET
PV
SV
OUT1 ALM1 ALM2OUT2AT
Initialize code selection display
Input type selection
R/S
SET
PV
SV
OUT1 ALM1 ALM2OUT2AT
Initialize code selection display
R/S
SET
PV
SV
OUT1 ALM1 ALM2OUT2AT