Rhein-Nadel Automation GmbH 13
VT-BA-ESR2000_EN_2023.docx
On / Off
Pressing this button switches off all connected devices. The display shows
"OFF". The controller remains ready for operation.
Cursor up and cursor down
Use these buttons to scroll through the controller menu or set the parame-
ters.
Enter
Press this button to acknowledge the parameters entered with the cursor.
Decimal point in the display
The decimal point is not blinking. You cannot make any entry.
The decimal point is blinking, an entry can be made.
To start up the controller, close the main disconnect switch. The main menu appears on the display show-
ing the last setpoint entered (feed rate of the bowl feeder or linear feeder).
Alternatively, the following may appear on the display depending on the switching status of the device:
External enabling signal has been activated but it is withdrawn from the device at the
moment.
(medium priority)
Device has been switched off by operating the top left button of the membrane key-
pad, inhibiting all functions. (high priority)
The accumulation monitoring sensor is operated, switching off the bowl feeder. (low
priority)
Display of setpoint or feed
rate of the bowl feeder
Alternatively: STOP, OFF
or ACCUMULATION (see
above)
Entry of the codes to
change or execute the re-
quired settings.
Enter code.
Description of codes
see under 4.4.
Setpoint setting
(bowl feeder or linear
feeder)
Entry in %; return to
display mode for
saving
Use the cursor buttons (UP/ DOWN) to scroll through these three basic screens of the main menu. In each
individual item of the main menu you can press ENTER to activate this item for setting or changing. Upon
pressing of the ENTER button the decimal point starts blinking. Now you can make changes using the cursor
4.1.2. The controller display (membrane keypad)
4.2. Starting-up the controller
4.3. Main menu / Setpoint entry and display
To Next Page
Loading...
Need help?
General
