RNA ESR 2000 - Code C100 Setting the Feed Rate by External Voltage Input; Code C143 Saving Parameters

To Next Page

To Previous Page

Rhein-Nadel Automation GmbH 21

VT-BA-ESR2000_EN_2023.docx

KANAL l

KANAL 2

CODE

Objective: Setpoint change by external voltage

Select code

KANAL l

KANAL 2

CODE

Select code

Code C100

KANAL l

KANAL 2

CODE

External voltage applica-

tion to channel 1

KANAL l

KANAL 2

CODE

I = active

0 = not active

Return

KANAL l

KANAL 2

CODE

Save and return to

main menu

If external voltage application is activated the last digital feed rate set (%) constitutes the mini-

mum feed rate for 0 volt. Set the maximum feed rate for 10 volt by the P parameter in C001.

Connect the external voltage to terminals 31, 32 and 33 in the controller.

You find the terminals behind the right-hand side panel.

Terminal 31 = +10V

Terminal 32 = E

Terminal 33 = 0V

Objective: Saving of application-specific parameters

Select code

KANAL l

KANAL 2

CODE

Select code

Code C143

Select memory location 0-

KANAL l

KANAL 2

CODE

Select code

Save

Return

Save and return to

main menu

US.I Selection of parameter set (0 – 3) in which the current parameters are to be stored.

PUSH Operate PUSH with ENTER and press a cursor button to save the current parameters to

the parameter set previously selected under US.I.

KANAL l

KANAL 2

CODE

KANAL l

KANAL 2

CODE

KANAL l

KANAL 2

CODE

4.5.8. Code C100 Setting the feed rate by external voltage input.

Attention!

Before opening the device be sure to observe the safety directives in chapter 2.

4.5.9. Code C143 Saving parameters

Main Page

RNA ESR 2000 - Code C100 Setting the Feed Rate by External Voltage Input; Code C143 Saving Parameters

Table of Contents

Related product manuals