If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
18
Scan sensitivity setting - FM
Your radio will normally scan for FM broadcasts which are strong enough
to give good reception. However, you may wish the Auto-scan function
to also be able to fi nd weaker signals, possibly from more distant radio
transmitters. Your radio includes a local / distant option for the Auto-scan
function.
1. Press and release the On/Standby button to switch on your sound
system.
2. Press and release the Mode button until the FM mode is selected.
3. Press and release the Menu button. The FM menu will show on the
display.
4. Press and release the Tuning Up or Down buttons until 'SCAN' shows
on the display. Press and release the Select button.
5. Press and release the Tuning Up or Down buttons to switch between
'LOCAL' and 'DISTANT' options on the display. The Distant option will
allow the radio to fi nd weaker signals when scanning.
6. Press and release the Select button to confi rm your selection. The
sound system will then revert to the normal information display. The
Local or Distant setting is stored in the radio and remains in force until
changed or until a System Reset.
Note: The initial setting (out of the box, or after a System Reset) causes
the radio to ignore weaker (or more distant) signals.
4,5
4,5
3
4,6
2
To Next Page
Loading...