7
Operating your sound system
1. Press and release the On/Standby button to switch on your sound
system.
When fi rst switched on, the sound system will be in DAB mode. After
each use the sound system will remember the mode used and then
switch on in that mode the next time that it is used.
2. If the radio has been used before, the last used station will be selected.
3. If this is the fi rst time that the radio has been used a scan of the Band
III DAB channels will be carried out (depending on whether scanning
was already completed in standby mode). During the scanning process
the display will show the progress of the station search. The number
on the right of the display is the number of stations that have been
found.
4. When the scan is completed the fi rst station (in numeric-alpha order
0...9, A...Z will be selected. The fi rst station in the list of stations found
during scanning will be played. The display will show the station name.
5. If no signals are found then it may be necessary to relocate your radio
to a position giving better reception. You should then carry out a scan
to fi nd stations as described on page 11.
• Your radio has an indicator
on the display to indicate the strength
of the DAB radio signal being received.
Note: When fi rst switched on, the radio will set the volume to a moderately
high level, in case the broadcast is very quiet. After you have set the
volume, the radio will remember the setting that you have applied for the
next time that it is used.
1
To Next Page
Loading...