37
Using USB memory devices
This section describes how to use your sound system to access and
playback your audio fi les via USB memory devices.
Important: Your sound system is only designed to work with USB memory
fl ash memory devices. It is not intended to be connected to hard disk drives
or any other type of USB device.
The Blutune 60 has been tested with a range of USB memory devices of
up to 32GB capacity. Memory must use the FAT or FAT 32 fi ling system
in order to operate in the Blutune 60.
Audio formats supported for playback are MP3 and WMA. Playback does
not support fi les encoded using WMA lossless, WMA Voice, WMA 10
professional, nor fi les of any format which have DRM protection.
1. The USB slot is located on the rear of your sound system.
A USB memory with MP3 or WMA fi les should not contain more than 999
fi les and not more than 99 folders. MP3 and WMA fi les should be created
with an audio sample rate of 44.1kHz (this is normal for fi les created from
CD audio content). MP3 and WMA data rates up to 320 kilobits per second
are supported. WMA Lossless, WMA Voice, WMA 10 Professional and
fi les which have DRM protection are not supported.
Note: If the sound system is in USB mode but not playing for more than 15
minutes then it will automatically switch to the standby mode.
The display
will revert to showing the standby mode clock. To use the sound system
again press the On/Standby button to switch it on.
Cautions:
In order to minimise the risk of damage to your sound system, or your
USB memory device, please place the unit such that the device cannot
easily be knocked while it is inserted in the socket.
Remove the USB memory before carrying the unit or if not using the USB
feature for a prolonged period.
Place the unit in Standby mode before removing the USB memory device.
1
To Next Page
Loading...