Roche Cobas 4800 System User Manual

cobas® 4800 System
6 Maintenance
Systeni Manual
A Conductor(-)
Analyzer nzaintenance
1
B Conductor
(+)
Figure 6-11 Remove the conductors
6 Instail the new Xenon lamp. First attach
the
(-)
conductor and then the (+)
conductor.
7 Complete the installation by following the above mentioned
steps 4 to 1 exactly in
the reverse order.
• Make sure the
(-)
conductor
points upward while fixing the new Xenon lamp into
the clamp.
• After replacing the
Xenon
lamp, reset the lamp counter by choosing the Reset
values after lamp exchange
button in the software. The analyzer monitors
the
actual lamp intensity
and
lifetime. 1f either of the two expires, you will be informed
and prompted to
exchange
the lamp. No run can be performed unless the lamp
has
been replaced.
0
Exchanging the ventilation
dust filters
NOTICE
Roche
Diagnostics
The electronic rack of the analyzer is cooled
by
ventilation.
Two ventilation inlets are
located in the lower right corner of the right side of the
analyzer (right beside the
block cycler compartment) and in the back of
the analyzer. To avoid any
contamination of the analyzer’s interior
by
dust particles,
these ventilation inlets
carry dust filters.
Instrument damage due to
insufficient
maintenance
The dust filters should be exchanged once a year. There is no indication from
the
software. You can order
exchange
dust filters directly from Roche.
-.\‘
:!!“
L._
oosbas
z
480
System Manual . Version
1.0
119

Roche Cobas 4800 System Specifications

General

Brand	Roche
Model	Cobas 4800 System
Category	Analytical Instruments
Language	English