Publication 1794-UM066B-EN-E - March 2015
20 Configure the Adapter for Your EtherNet/IP Network
The device is added to the Relation List, displaying the Ethernet Address
(MAC) and corresponding IP Address, Hostname and Description (if
applicable).
When the IP address assignment is made, the address displays in the IP
Address column in the Request History section.
4. To assign this configuration to the device, highlight the device in the
Relation List panel and click Disable BOOTP/DHCP. When power is
cycled to the device, it uses the configuration you assigned and not does
not issue a DHCP request.
To enable DHCP for a device that has had DHCP disabled, highlight the
device in the Relation List and click Enable DHCP. You must have an
entry for the device in the Relation List panel to re-enable DHCP.
To Next Page
Loading...
Need help?
General
