Rockwell Automation Allen-Bradley PowerFlex 700 - Page 139

Index-7
Drive Logic Rslt, 1-50
Drive OL Count, 1-44
Drive OL Mode, 1-31
Drive Ramp Rslt, 1-50
Drive Ref Rslt, 1-50
Drive Status 1, 1-41
Drive Temp, 1-44
Droop RPM @ FLA, 1-32
Elapsed kWh, 1-13
Elapsed MWH, 1-12
Elapsed Run Time, 1-12
Enc Position Fdbk, 1-20
Encoder PPR, 1-20
Encoder Speed, 1-20
Encoder Z Chan, 1-21
Fault 1 Time, 1-48
Fault Amps, 1-44
Fault Bus Volts, 1-45
Fault Clear, 1-46
Fault Clear Mode, 1-47
Fault Clr Mask, 1-52
Fault Config x, 1-46
Fault Frequency, 1-44
Fault Speed, 1-44
Fault x Code, 1-47
Fdbk Filter Sel, 1-20
Feedback Select, 1-22
Float Tolerance, 1-61
Flux Braking, 1-34
Flux Current, 1-12
Flux Current Ref, 1-17
Flux Up Mode, 1-16
Flux Up Time, 1-16
Flying Start En, 1-35
Flying StartGain, 1-35
Gnd Warn Level, 1-37
Inertia Autotune, 1-18
IR Voltage Drop, 1-17
Ixo Voltage Drop, 1-17
Jog Mask, 1-52
Jog Owner, 1-52
Jog Speed, 1-25
Kf Speed Loop, 1-30
Ki Speed Loop, 1-29
Kp Speed Loop, 1-30
Language, 1-40
Last Stop Source, 1-43
Load Frm Usr Set, 1-2, 1-40
Load Loss Level, 1-38
Load Loss Time, 1-38
Local Mask, 1-52
Local Owner, 1-53
Logic Mask, 1-51
Man Ref Preload, 1-39
Marker Pulse, 1-21
Maximum Freq, 1-16
Maximum Speed, 1-22
Maximum Voltage, 1-15
MicroPos Scale%, 1-61
Minimum Speed, 1-22
MOP Frequency, 1-13
MOP Mask, 1-52
MOP Owner, 1-53
MOP Rate, 1-39
MOP Reference, 1-13
Motor Cntl Sel, 1-15
Motor Fdbk Type, 1-20
Motor NP FLA, 1-14
Motor NP Hertz, 1-14
Motor NP Power, 1-15
Motor NP RPM, 1-14
Motor NP Volts, 1-14
Motor OL Count, 1-44
Motor OL Factor, 1-15
Motor OL Hertz, 1-15
Motor Poles, 1-15
Motor Type, 1-14
Mtr NP Pwr Units, 1-15
Mtr Tor Cur Ref, 1-19
Neg Torque Limit, 1-19
Notch Filter Freq, 1-20
Notch Filter K, 1-21
Output Current, 1-12
Output Freq, 1-12
Output Power, 1-12
Output Powr Fctr, 1-12
Output Voltage, 1-12
Overspeed Limit, 1-22
Param Access Lvl, 1-39
PI BW Filter, 1-29
PI Configuration, 1-27
PI Control, 1-27
PI Deriv Time, 1-29
PI Error Meter, 1-29
PI Fdback Meter, 1-28
PI Feedback Hi, 1-29
PI Feedback Lo, 1-29
PI Feedback Sel, 1-28
PI Integral Time, 1-28
PI Lower Limit, 1-28
PI Output Meter, 1-29
PI Preload, 1-28
PI Prop Gain, 1-28
PI Ref Meter, 1-28
PI Reference Hi, 1-29
PI Reference Lo, 1-29
PI Reference Sel, 1-27
PI Setpoint, 1-27
20B-UM001.book Page 7 Thursday, June 20, 2013 1:55 PM