Index-8
PI Status, 1-28
PI Upper Limit, 1-28
Pos Torque Limit, 1-19
Power Loss Level, 1-38
Power Loss Mode, 1-37
Power Loss Time, 1-37
Powerup Delay, 1-34
PowerUp Marker, 1-47
Preset Speed x, 1-25
Pulse In Scale, 1-21
Pulse Input Ref, 1-25
PWM Frequency, 1-31
Ramped Speed, 1-13
Rated Amps, 1-14
Rated kW, 1-14
Rated Volts, 1-14
Reference Mask, 1-52
Reference Owner, 1-53
Regen Power Limit, 1-32
Reset Meters, 1-40
Reset To Defalts, 1-40
Rev Speed Limit, 1-23
Run Boost, 1-19
S Curve %, 1-31
Save HIM Ref, 1-39
Save MOP Ref, 1-39
Save To User Set, 1-40
Scale In Hi, 1-49
Scale In Lo, 1-49
Scale In Value, 1-49
Scale Out Hi, 1-49
Scale Out Lo, 1-49
Scale Out Value, 1-49
Shear Pin Time, 1-38
Skip Freq Band, 1-23
Skip Frequency x, 1-23
Sleep Level, 1-37
Sleep Time, 1-37
Sleep-Wake Mode, 1-36
Sleep-Wake Ref, 1-37
Slip Comp Gain, 1-26
Slip RPM @ FLA, 1-26
Slip RPM Meter, 1-26
SpdBand Integrat, 1-61
Speed Desired BW, 1-30
Speed Dev Band, 1-61
Speed Feedback, 1-13
Speed Loop Meter, 1-30
Speed Mode, 1-22
Speed Ref A Hi, 1-24
Speed Ref A Lo, 1-24
Speed Ref A Sel, 1-24
Speed Ref B Hi, 1-24
Speed Ref B Lo, 1-24
Speed Ref B Sel, 1-24
Speed Ref Source, 1-43
Speed Reference, 1-13
Speed Units, 1-21
Speed/Torque Mod, 1-23
Start At PowerUp, 1-34
Start Inhibits, 1-43
Start Mask, 1-51
Start Owner, 1-52
Start/Acc Boost, 1-19
Status 1 @ Fault, 1-45
Stop Mode x, 1-32
Stop Owner, 1-52
Stop/BRK Mode x, 1-32
SV Boost Filter, 1-16
TB Man Ref Hi, 1-25
TB Man Ref Lo, 1-25
TB Man Ref Sel, 1-25
Testpoint 1 Sel, 1-46
Testpoint x Data, 1-46
Torq Ref A Div, 1-18
TorqLim SlewRate, 1-61
TorqProve C n f g , 1-60
TorqProve S e t up , 1-60
Torque Current, 1-12
Torque Perf Mode, 1-15
Torque Ref B Mult, 1-2, 1-18
Torque Ref x Hi, 1-18
Torque Ref x Lo, 1-18
Torque Ref x Sel, 1-18
Torque Setpoint, 1-19
Torque Setpoint2, 1-19
Total Inertia, 1-30
Trim % Setpoint, 1-26
Trim H i , 1-26
Trim In Select, 1-26
Trim L o , 1-26
Trim O u t Se le c t , 1-26
Voltage Class, 1-41
Wake Level, 1-37
Wake Time, 1-37
Zero SpdFloatTime, 1-61
Params Defaulted Fault, 2-7
Phase Short Fault, 2-7
Phase to Grnd Fault, 2-7
PI BW Filter, 1-29
PI Configuration, 1-27
PI Control, 1-27
PI Deriv Time, 1-29
PI Error Meter, 1-29
PI Fdback Meter, 1-28
PI Feedback Hi, 1-29
20B-UM001.book Page 8 Thursday, June 20, 2013 1:55 PM
To Next Page
Loading...
