Rohde & Schwarz FSW43 - Page 1029

Remote Commands
R&S
®
FSW
1029User Manual 1173.9411.02 ─ 19
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1
Example:
DISP:ANN:CBAR OFF
Usage: SCPI confirmed
Manual operation: See "Channel Bar" on page 594
DISPlay:ANNotation:FREQuency <State>
This command turns the label of the x-axis on and off.
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1
Example:
DISP:ANN:FREQ OFF
Usage: SCPI confirmed
Manual operation: See "Diagram Footer (Annotation)" on page 594
DISPlay:PSAVe:HOLDoff <Minutes>
This command defines the time until the R&S FSW turns the display power save mode
on.
Parameters:
<Minutes> Minutes until power save mode starts. Note that the number you
enter may have no dimension.
Range: 1 to 100
*RST: 15
Example:
DISP:PSAV:HOLD 30
Manual operation: See "Display Power Save Function" on page 592
DISPlay:PSAVe[:STATe] <State>
This command turns the power save mode of the display on and off.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
DISP:PSAVe ON
Switches on the power-save mode.
Manual operation: See "Display Power Save Function" on page 592
Configuring the R&S FSW