Rohde & Schwarz FSW43 - Page 1030

Remote Commands
R&S
®
FSW
1030User Manual 1173.9411.02 ─ 19
DISPlay:SBAR[:STATe] <State>
This command turns the status bar on and off.
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1
Example:
DISP:SBAR:OFF
Manual operation: See "Status Bar" on page 593
DISPlay:
SKEYs[:STATe] <State>
This command turns the softkey bar on and off.
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1
Example:
DISP:SKEY:OFF
Manual operation: See "Softkey Bar" on page 594
DISPlay:TBAR[:STATe] <State>
This command turns the toolbar on or off.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
DISP:TOOL ON
Manual operation: See "Toolbar" on page 593
DISPlay:TOUChscreen:STATe <State>
This command controls the touch screen functionality.
Parameters:
<State> ON | 1
Touch screen is active for entire screen
OFF | 0
Touch screen is inactivate for entire screen
FRAMe
Touch screen is inactivate for the diagram area of the screen,
but active for softkeys, toolbars and menus.
*RST: 1
Example:
DISP:TOUC:STAT ON
Manual operation: See "Deactivating and Activating the Touchscreen" on page 591
Configuring the R&S FSW