Rohde & Schwarz FSW43 - Page 149

Measurements
R&S
®
FSW
149User Manual 1173.9411.02 ─ 19
The easiest way to configure a measurement is using the configuration "Overview",
see chapter 6.1, "Configuration Overview", on page 312.
The remote commands required to perform these tasks are described in chap-
ter 11.5.3, "Measuring the Channel Power and ACLR", on page 700.
● General CP/ACLR Measurement Settings............................................................149
● Channel Setup...................................................................................................... 155
5.3.4.1 General CP/ACLR Measurement Settings
General measurement settings are defined in the "ACLR Setup" dialog, in the "General
Settings" tab.
Standard......................................................................................................................150
└ Predefined Standards................................................................................... 150
└ User-Defined Standards............................................................................... 150
Number of Channels (Tx, ADJ)...................................................................................152
Reference Channel..................................................................................................... 152
Noise cancellation.......................................................................................................153
Fast ACLR...................................................................................................................153
Selected Trace............................................................................................................153
Absolute and Relative Values (ACLR Mode).............................................................. 153
Channel Power Levels and Density (Power Unit)....................................................... 154
Power Mode................................................................................................................154
Channel Power and Adjacent-Channel Power (ACLR) Measurement