Rohde & Schwarz FSW43 - Page 159

Measurements
R&S
®
FSW
159User Manual 1173.9411.02 ─ 19
is selected (see "Standard" on page 150), the "ACLR Setup" dialog box is replaced by
the "MSR ACLR Setup" dialog box.
To display the "MSR ACLR Setup" dialog box, do one of the following:
●
Select the "CP/ACLR Standard" softkey from the "CH Power" menu and select the
"Multi-Standard Radio" standard. Then select the "CP/ACLR Config" softkey.
●
Select the "CP/ACLR Config" softkey from the "CH Power" menu. Then select the
"Multi-Standard Radio" standard from the "Standard" selection list.
For more information see chapter 5.3.3.4, "Measurement on Multi-Standard Radio
(MSR) Signals", on page 145.
The remote commands required to perform these tasks are described in chap-
ter 11.5.3, "Measuring the Channel Power and ACLR", on page 700.
● General MSR ACLR Measurement Settings.........................................................159
● MSR Sub block and Tx Channel Definition...........................................................164
● MSR Adjacent and Gap Channel Setup................................................................167
5.3.5.1 General MSR ACLR Measurement Settings
General MSR ACLR measurement settings are defined in the "MSR ACLR Setup" dia-
log, in the "MSR General Settings" tab.
Standard......................................................................................................................160
└ Predefined Standards................................................................................... 160
└ User-Defined Standards............................................................................... 160
Number of Sub blocks.................................................................................................162
Reference Channel..................................................................................................... 162
Noise cancellation.......................................................................................................162
Selected Trace............................................................................................................163
Absolute and Relative Values (ACLR Mode).............................................................. 163
Channel Power Levels and Density (Power Unit)....................................................... 163
Power Mode................................................................................................................164
Optimized Settings (Adjust Settings)...........................................................................164
Channel Power and Adjacent-Channel Power (ACLR) Measurement