Rohde & Schwarz FSW43 - Page 212

Measurements
R&S
®
FSW
212User Manual 1173.9411.02 ─ 19
Sweep Time
Sets the sweep time value for the range.
For details on the sweep time see chapter 6.5.1.7, "How Long the Data is Measured:
Sweep Time", on page 407
Remote command:
[SENSe:]ESPectrum<sb>:RANGe<range>:SWEep:TIME on page 746
Ref. Level
Sets the reference level for the range.
For details on the reference level see chapter 6.4.1.1, "Reference Level",
on page 393.
Remote command:
[SENSe:]ESPectrum<sb>:RANGe<range>:RLEVel on page 746
RF Att. Mode
Activates or deactivates the auto mode for RF attenuation.
For details on attenuation see chapter 6.4.1.2, "RF Attenuation", on page 394.
Remote command:
[SENSe:]ESPectrum<sb>:RANGe<range>:INPut:ATTenuation:AUTO
on page 738
RF Attenuator
Sets the attenuation value for the range.
For details on attenuation see chapter 6.4.1.2, "RF Attenuation", on page 394.
Remote command:
[SENSe:]ESPectrum<sb>:RANGe<range>:INPut:ATTenuation on page 737
Preamp
Switches the preamplifier on or off.
For details on the preamplifier see "Preamplifier (option B24)" on page 399.
Remote command:
[SENSe:]ESPectrum<sb>:RANGe<range>:INPut:GAIN:STATe on page 738
Transd. Factor
Sets a transducer for the specified range. You can only choose a transducer that fulfills
the following conditions:
●
The transducer overlaps or equals the span of the range.
●
The x-axis is linear.
●
The unit is dB.
For details on transducers see chapter 9.2, "Basics on Transducer Factors",
on page 566.
Remote command:
[SENSe:]ESPectrum<sb>:RANGe<range>:TRANsducer on page 747
Spectrum Emission Mask (SEM) Measurement