Remote Commands
R&S
®
FSW
747User Manual 1173.9411.02 ─ 19
[SENSe:]ESPectrum<sb>:RANGe<range>:SWEep:TIME:AUTO <State>
This command turns automatic selection of the sweep time for a SEM range on and
off.
In case of high speed measurements, the sweep time has to be identical for all ranges.
Suffix:
<sb>
.
1 | 2 | 3
Sub block in a Multi-SEM measurement
<range> 1..30
Selects the measurement range.
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1
Example:
ESP:RANG3:SWE:TIME:AUTO OFF
Deactivates the sweep time auto mode for range 3.
Manual operation: See "Sweep Time Mode" on page 211
[SENSe:]ESPectrum<sb>:RANGe<range>:TRANsducer <Transducer>
This command selects a transducer factor for a SEM range.
Note that
●
the transducer must cover at least the span of the range
●
the x-axis has to be linear
●
the unit has to be dB
Suffix:
<sb>
.
1 | 2 | 3
Sub block in a Multi-SEM measurement
<range> 1..30
Selects the measurement range.
Parameters:
<Transducer> String containing the transducer file name, including the path
information.
Manual operation: See "Transd. Factor" on page 212
11.5.6.5 Configuring the Reference Range
The following commands define the reference range for the SEM sweep list.
[SENSe:]ESPectrum<sb>:BWID......................................................................................748
[SENSe:]ESPectrum<sb>:FILTer[:RRC]:ALPHa................................................................748
[SENSe:]ESPectrum<sb>:FILTer[:RRC][:STATe].............................................................. 748
[SENSe:]ESPectrum<sb>:RRANge?................................................................................748
[SENSe:]ESPectrum<sb>:RTYPe....................................................................................749
Configuring and Performing Measurements
To Next Page
Loading...
