Common Measurement Settings
R&S
®
FSW
347User Manual 1173.9411.02 ─ 19
Result Frequency Stop
For reference only: The stop frequency for the generator, calculated from the config-
ured generator frequency and the stop value defined for the R&S FSW.
Source Calibration Functions
The calibration functions of the external generator are available in the "Source Calibra-
tion" subtab of the "External Generator" tab, but only if external generator control is
active (see "Source State" on page 345).
Calibrate Transmission............................................................................................... 347
Calibrate Reflection Short........................................................................................... 347
Calibrate Reflection Open...........................................................................................348
Source Calibration Normalize..................................................................................... 348
Recall.......................................................................................................................... 348
Save As Trd Factor..................................................................................................... 348
Reference Position......................................................................................................349
Reference Value......................................................................................................... 349
Calibrate Transmission
Starts a transmission type measurement to determine a reference trace. This trace is
used to calculate the difference for the normalized values.
For details see "Calibration Mechanism" on page 335.
Remote command:
[SENSe:]CORRection:METHod on page 890
Calibrate Reflection Short
Starts a short-circuit reflection type measurement to determine a reference trace for
calibration.
Data Input and Output
To Next Page
Loading...
