General Instrument Setup
R&S
®
FSW
573User Manual 1173.9411.02 ─ 19
●
dBμA/m
●
dBpW
●
dBpT
Compatibility
Indicates whether the transducer factors are compatible with the current measurement
settings.
For more information on which conditions a transducer line must fulfill to be compati-
ble, see chapter 9.2, "Basics on Transducer Factors", on page 566.
Activating/Deactivating
Activates/deactivates the transducer line. Up to 8 transducer lines can be active at the
same time.
Remote command:
[SENSe:]CORRection:TRANsducer:SELect on page 1027
[SENSe:]CORRection:TRANsducer[:STATe] on page 1027
Comment
An optional description of the transducer line.
Included Lines in Overview (View Filter)
Defines which of the stored lines are included in the overview. The view can be restric-
ted to compatible lines only or include all lines found. Whether a line is compatible or
not is indicated in the Compatibility setting.
Adjusting the Reference Level
Activates or deactivates the automatic adjustment of the reference level to the selected
transducer factor.
"Auto"
Activates the automatic adjustment. The original dynamic range is
restored by shifting the reference level by the maximum transducer
factor.
"Man"
Deactivates the automatic adjustment. Adjust the reference level via
the "Amplitude" menu.
Remote command:
[SENSe:]CORRection:TRANsducer:ADJust:RLEVel[:STATe] on page 1026
Create New Line
Create a new transducer line.
Remote command:
[SENSe:]CORRection:TRANsducer:SELect on page 1027
Edit Line
Edit an existing transducer line configuration.
Copy Line
Copy the selected transducer line configuration to create a new line.
General Instrument Settings
To Next Page
Loading...
