Rohde & Schwarz FSW43 - Page 653

Network and Remote Operation
R&S
®
FSW
653User Manual 1173.9411.02 ─ 19
Language.................................................................................................................... 653
IF Gain........................................................................................................................ 654
Sweep Repeat.............................................................................................................654
Coupling......................................................................................................................654
Wideband....................................................................................................................654
FSU/FSQ Preamplifier................................................................................................ 655
Revision String............................................................................................................655
Resetting the Factory Revision................................................................................... 655
Language
Defines the system language used to control the instrument.
For details on the available GPIB languages, see chapter 11.13.2, "Reference: GPIB
Commands of Emulated HP Models", on page 1053.
Note: Emulating previous R&S signal and spectrum analyzers. As of firmware version
1.60, this function is also used to emulate previous R&S signal and spectrum ana-
lyzers.
As a rule, the R&S FSW supports most commands from previous R&S signal and
spectrum analyzers such as the FSQ, FSP, FSU, or FSV. However, the default values,
in particular the number of sweep points or particular bandwidths, may vary. Therefore,
the R&S FSW can emulate these other devices, including their default values, in order
to repeat previous measurements or support existing control applications as in legacy
systems.
Network and Remote Control Settings