Remote Commands
R&S
®
FSW
718User Manual 1173.9411.02 ─ 19
Manual operation: See "Tx Channel Bandwidth" on page 167
[SENSe:]POWer:ACHannel:SBLock<sb>:CENTer[:CHANnel<ch>] <Frequency>
This command defines the (absolute) center frequency of the specified MSR Tx chan-
nel.
Note that the position of the first Tx channel in the first sub block and the last Tx chan-
nel in the last sub block also affect the position of the adjacent channels.
This command is for MSR signals only (see CALCulate<n>:MARKer<m>:
FUNCtion:POWer:PRESet on page 700).
Suffix:
<sb>
.
1 | 2 | 3 | 4 | 5
sub block number
Parameters:
<Frequency> absolute frequency in Hz
Manual operation: See "Tx Center Frequency" on page 166
[SENSe:]POWer:ACHannel:SBLock<sb>:FREQuency:CENTer <Frequency>
This command defines the center of the specified MSR sub block. Note that the posi-
tion of the sub block also affects the position of the adjacent gap (CACLR) channels.
This command is for MSR signals only (see CALCulate<n>:MARKer<m>:
FUNCtion:POWer:PRESet on page 700).
Suffix:
<sb>
.
1 | 2 | 3 | 4 | 5
sub block number
Parameters:
<Frequency> absolute frequency in Hz
Manual operation: See "Sub block Center Frequency" on page 166
[SENSe:]POWer:ACHannel:SBLock<sb>:NAME[:CHANnel<ch>]? <Name>
This command queries the name of the specified MSR Tx channel.
In MSR ACLR measurements, TX channel names correspond to the specified technol-
ogy, followed by a consecutive number. The assigned sub block (A,B,C,D,E) is indica-
ted as a prefix (e.g. A: WCDMA1). Channel names cannot be defined manually.
This command is for MSR signals only (see CALCulate<n>:MARKer<m>:
FUNCtion:POWer:PRESet on page 700).
Suffix:
<sb>
.
1 | 2 | 3 | 4 | 5
sub block number
Configuring and Performing Measurements
To Next Page
Loading...
